Theoretical and technological aspects of production mechani‑cally alloyed powders for the production of coatings and products by additive methods-Reference-Cited by-同舟云学术

Theoretical and technological aspects of production mechani‑cally alloyed powders for the production of coatings and products by additive methods

Published:2021-12-20 Issue:4 Volume: Page:90-105
ISSN:2414-0406
Container-title:Litiyo i Metallurgiya (FOUNDRY PRODUCTION AND METALLURGY)
language:
Short-container-title:Litʹë metall.

Author:

Lovshenko F. G.¹,Fedosenko A. S.¹,Marukovich E. I.²

Affiliation:

1. Belarusian‑Russian University

2. Institute of Technology of Metals of National Academy of Sciences of Belarus

Abstract

The established regularities of the formation of powders based on iron and nickel, obtained by the method of mechanical alloying and intended for the deposition of thermal spraying coatings, as well as the manufacture of products by layer‑by‑layer synthesis. The structure, phase composition and properties of materials are investigated. Powders consist of particles with a size of 20–70 microns, differ in the submicrocrystalline type structures, and nonequilibrium phase composition. Thermal spray coatings made of them have a set of properties that significantly exceed the properties of coatings made of commercially available materials. The diameter of the grains of the material obtained by the SLМ method from the synthesized powder is 1.5–2.0 times smaller than that produced from the powder of 316L steel, and the heat resistance is higher.

Publisher

Belarusian National Technical University

Subject

Pulmonary and Respiratory Medicine,Pediatrics, Perinatology, and Child Health

Reference26 articles.

1. Zlenko M.A., Popovich A.A., Mutylina I. N. Additivnye tehnologii v mashinostroenii [Additive technologies in mechanical engineering]. Sankt‑Peterburg, Politehnicheskij universitet Publ., 2013, 222 p.

2. The Current State of Additive Manufacturing in Wind Energy Systems [Electronic resource] / B. Post [et al.]. – Mode of access: https://info.ornl.gov/sites/publications/Files/Pub103095.pdf. – Date of access: 28.06.19

3. Thomas, D. S. Costs and Cost Effectiveness of Additive Manufacturing /D.S. Thomas, S. W. Gilber// [Electronic resource]. – Mode of access: http://dx.doi.org/10.6028/NIST.SP.1176. – Date of access: 28.05.2019.

4. Research and Development of Additive Manufactured Bladed Disks [Elec‑tronic resource] / J.A. Bayliff [et al.]. – Mode of access: http://publications.lib.chalmers.se/records/fulltext/250277/250277.pdf. – Date of access: 29.06.2019.

5. Laser Metal Deposition as Repair Technology for a Gas Turbine Burner Made of Inconel 718 / T. Petrat [et al.]// Physics Procedia, 2016, vol. 83, pp. 761–768.

Cited by 1 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Investigation of the Elemental Composition of Titanium Metal Waste by X-Ray Fluorescence Analysis;Proceedings of the Southwest State University. Series: Engineering and Technology;2024-04-10