A comparative study of lubricated friction and wear behaviour of Al–25Zn–3Cu–3Si bearing alloy-Reference-Cited by-同舟云学术

A comparative study of lubricated friction and wear behaviour of Al–25Zn–3Cu–3Si bearing alloy

Published:2014-05-30 Issue:8 Volume:228 Page:896-903
ISSN:1350-6501
Container-title:Proceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology
language:en
Short-container-title:Proceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology

Author:

Bican Osman¹,Savaşkan Temel²

Affiliation:

1. Department of Metallurgical and Materials Engineering, Kırıkkale University, Kırıkkale, Turkey

2. Department of Mechanical Engineering, Karadeniz Technical University, Trabzon, Turkey

Abstract

Lubricated friction and wear behaviour of Al–25Zn–3Cu–3Si alloy was investigated on a block-on-disc test machine in comparison with 60/40 brass and SAE 65 bronze. T6 heat treatment increased the hardness, strength and wear resistance of the Al–25Zn–3Cu–3Si alloy. This alloy exhibited much higher wear resistance than the 60/40 brass and SAE 65 bronze in both as-cast and heat-treated conditions. The results obtained from the experimental alloys are discussed in terms of their microstructure, mechanical properties and wear behaviour.

Publisher

SAGE Publications

Subject

Surfaces, Coatings and Films,Surfaces and Interfaces,Mechanical Engineering

Link

http://journals.sagepub.com/doi/pdf/10.1177/1350650114537473

Reference20 articles.

1. Mechanical properties and lubricated wear of Zn-25Al-based alloys

2. Tribological behaviour of ZnAl alloys (ZA27) compared with bronze when used as a bearing material with high load and at very low speed

3. Comparative wear behaviour of Zn-Al-based alloys in an automotive engine application

4. Mechanical and tribological properties of Al–40Zn–Cu alloys

5. Effects of pressure and sliding speed on the friction and wear properties of Al–40Zn–3Cu–2Si alloy: A comparative study with SAE 65 bronze

Cited by 8 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Research on Preparation and Properties of Carbon Fiber Reinforced Zinc-Based Aluminum Rich Alloy Composite;Materials;2022-01-30

2. Optimization of dry sliding wear characteristics of Al–25Zn/SiC hybrid composites by graphite reinforcement using artificial neural network and Taguchi’s method;Tribology - Materials, Surfaces & Interfaces;2021-11-17

3. Investigation of interaction of extreme pressure additive, load and sliding speed parameters with silver nano-particles in wear environment;Surface Topography: Metrology and Properties;2021-11-01

4. Pin Temperature and Al2O3 Fillings Effect on Sliding Wear Characteristics of Al–25Zn/Al2O3 Composites;Proceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology;2021-06-14

5. Study on the ultimate load carrying capacity of journal bearings with different materials and surface treating processes;IOP Conference Series: Materials Science and Engineering;2019-11-01