Affiliation:
1. Guru Nanak Dev University
2. Khalsa College of Engineering and Technology
3. Eternal University
Abstract
Gas detection instruments are increasingly needed for industrial health and safety, environmental monitoring, and process control. To meet this demand, considerable research into new sensors is underway, including efforts to enhance the performance of traditional devices, such as resistive metal oxide sensors, through nanoengineering. The resistance of semiconductors is affected by the gaseous ambient. The semiconducting metal oxides based gas sensors exploit this phenomenon. Physical chemistry of solid metal surfaces plays a dominant role in controlling the gas sensing characteristics. Metal oxide sensors have been utilized for several decades for low-cost detection of combustible and toxic gases. Recent advances in nanomaterials provide the opportunity to dramatically increase the response of these materials, as their performance is directly related to exposed surface volume. Proper control of grain size remains a key challenge for high sensor performance. Nanoparticles of SnO2have been synthesized through chemical route at 5, 25 and 50°C. The synthesized particles were sintered at 400, 600 and 800°C and their structural and morphological analysis was carried out using X-ray diffraction (XRD) and transmission electron microscopy (TEM). The reaction temperature is found to be playing a critical role in controlling nanostructure sizes as well as agglomeration. It has been observed that particle synthesized at 5 and 50°C are smaller and less agglomerated as compared to the particles prepared at 25°C. The studies revealed that particle size and agglomeration increases with increase in sintering temperature. Thick films gas sensors were fabricated using synthesized tin dioxide powder and sensing response of all the sensors to ethanol vapors was investigated at different temperatures and concentrations. The investigations revealed that sensing response of SnO2nanoparticles is size dependent and smaller particles display higher sensitivity. Table of Contents
Publisher
Trans Tech Publications, Ltd.
Subject
Condensed Matter Physics,General Materials Science,Atomic and Molecular Physics, and Optics
Reference66 articles.
1. M.J. Madou and S.R. Morrison, Chemical Sensing with Solid State Devices, Academic Press, New York, (1989).
2. W. Gopel and K.D. Schierbaum, Current status and future prospects, Sens. Actuators B Chem. 26- 27 (1995) 1-12.
3. G. Eranna, B.C. Joshi, D.P. Runthala and R.P. Gupta, Oxide materials for development of integrated gas sensors-a comprehensive review, Sol. St. Mater. Sci. 29 (2004) 111-188.
4. G. Korotcenkov, Practical aspects in design of one-electrode semiconductor gas sensors, Sens. Actuators B Chem. 121 (2) (2007) 664-678.
5. B. Hoffheins, Solid State, Resistive Gas Sensors, in: R.F. Taylor and J.S. Schultz (Eds. ), Handbook of Chemical and Biological Sensors, Philadelphia: Institute of Physics, (1996).
Cited by
7 articles.
订阅此论文施引文献
订阅此论文施引文献,注册后可以免费订阅5篇论文的施引文献,订阅后可以查看论文全部施引文献