COMPARING THE PERFORMANCE OF USING NANOFLUIDS IN TWO DIFFERENT TYPES OF HEAT EXCHANGERS WITH THE SAME HEAT TRANSFER AREA

Abstract

Using multi-wall carbon nanotubes (MWCNTs) based on distilled water with varied volume concentrations, experimental research was conducted. The performance of two distinct heat exchangers with the same heat transfer area was assessed. A tubular heat exchanger (THE) and a shell-and-tube heat exchanger (STHE) with a heat transfer area of 20,000 mm² were employed. A tubular heat exchanger (HT31) and a shell-and-tube heat exchanger (HT33) are available from Armfield for use with the heat exchange service unit (HT30X). Three volume concentrations of nanomaterials are used to create nanofluids (0.5%, 1%, 2%). While the rate of flow was the same in the heat exchangers, the Reynolds number of the flow inside the tube ranged from 1600 to 7800 for THE and from 2500 to 12,500 for STHE due to different inside diameters. The measured variables determine the coefficient of heat transfer, friction factor, Nusselt number, and effectiveness. The heat transfer coefficient in both heat exchangers was boosted with increasing MWCNT content, according to the experimental data. Because of the nanoparticle concentration, the heat transfer coefficient of STHE is 7-43% greater than that of THE. With the increase of nanofluid concentration, the Nusselt numbers were enhanced for the two heat exchangers. The increase in the Nu number for THE is higher than in its value for STHE within a range of 28.5-40%. Correlations between the Reynolds number and MWCNT volume concentration are proposed for each heat exchanger to compute the Nusselt number and friction factor. The results of the current study have been compared with previous studies and acceptable agreement can be found.