Abstract
Introduction:
This study evaluates the role of anatomic scapular morphology in acromion and scapular spine fracture (SSAF) risk after reverse shoulder arthroplasty (RSA).
Methods:
Twelve scapular measurements were captured based on pilot study data, including scapular width measurements at the acromion (Z1), middle of the scapular spine (Z2), and medial to the first major angulation (Z3). Measurements were applied to 3D-CT scans from patients who sustained SSAF after RSA (SSAF group) and compared with those who did not (control group). Measurements were done by four investigators, and the intraclass correlation coefficient was calculated. Regression analysis determined trends in fracture incidence.
Results:
One hundred forty-nine patients from two separate surgeons (J.L., A.M.) were matched by age and surgical indication of whom 51 sustained SSAF after reverse shoulder arthroplasty. Average ages for the SSAF and control cohorts were 78.6 and 72.1 years, respectively. Among the SSAF group, 15 were Levy type I, 26 Levy type II, and 10 Levy type 3 fractures. The intraclass correlation coefficient of Z1, Z2, and Z3 measurements was excellent (0.92, 0.92, and 0.94, respectively). Zone 1 and 3 measurements for the control group were 18.6 ± 3.7 mm and 3.2 ± 1.0 mm, respectively, compared with 22.5 ± 5.9 mm and 2.0 ± 0.70 mm in the SSAF group, respectively. The fracture group trended toward larger Z1 and smaller Z3 measurements. The average scapular spine proportion (SSP), Z1/Z3, was significantly greater in the control 6.20 ± 1.80 versus (12.60 ± 6.30; P < 0.05). Regression analysis showed a scapular spine proportion of ≤5 was associated with a fracture risk <5%, whereas an SSP of 9.2 correlated with a 50% fracture risk.
Discussion:
Patients with a thicker acromions (Z1) and thinner medial scapular spines (Z3) have increased fracture risk. Understanding anatomic scapular morphology may allow for better identification of high-risk patients preoperatively.
Publisher
Ovid Technologies (Wolters Kluwer Health)