Electroadsorption of Bromide from Natural Water in Granular Activated Carbon

Abstract

The adsorption and electroadsorption of bromide from natural water has been studied in a filter-press electrochemical cell using a commercial granular activated carbon as the adsorbent. During electroadsorption experiments, different voltages were applied (2 V, 3 V and 4 V) under anodic conditions. The presence of the electric field improves the adsorption capacity of the activated carbon. The decrease in bromide concentration observed at high potentials (3 V or 4 V) may be due to the electrochemical transformation of bromide to Br2. The anodic treatment produces a higher decrease in the concentration of bromide in the case of cathodic electroadsorption. Moreover, in this anodic electroadsorption, if the system is again put under open circuit conditions, no desorption of the bromide is produced. In the case of anodic treatment in the following adsorption process after 24 h of treatment at 3 V, a new decrease in the bromide concentration is observed as a consequence of the decrease in bromide concentration after the electrochemical stage. It can be concluded that the electroadsorption process is effective against the elimination of bromide and total bromine in water, with a content of 345 and 470 µg L−1, respectively, reaching elimination values of 46% in a single-stage electroadsorption process in bromide and total bromine. The application of the electric field to the activated carbon with a positive polarization (anodic electroadsorption) increases the adsorption capacity of the activated carbon significantly, achieving a reduction of up to 220 µg L−1 after 1 h of contact with water. The two stage process in which a previous electrochemical oxidation is incorporated before the electroadsorption stage significantly increased the efficiency from 46% in a single electroadsorption step at 3 V, to 59% in two stages.