Fabrication and Performance of Continuous 316 Stainless Steel Fibre-Reinforced 3D-Printed PLA Composites

Abstract

This study investigates the feasibility of 3D printing continuous stainless steel fibre-reinforced polymer composites. The printing study was carried out using 316L stainless steel fibre (SSF) bundles with an approximate diameter of 0.15 mm. This bundle was composed of 90 fibres with a 14 μm diameter. This fibre bundle was first coated with polylactic acid (PLA) in order to produce a polymer-coated continuous stainless steel filament, with diameters tailored in the range from 0.5 to 0.9 mm. These filaments were then used to print composite parts using the material extrusion (MEX) technique. The SSF’s volume fraction (Vf) was controlled in the printed composite structures in the range from 4 to 30 Vf%. This was facilitated by incorporating a novel polymer pressure vent into the printer nozzle, which allowed the removal of excess polymer. This thus enabled the control of the metal fibre content within the printed composites as the print layer height was varied in the range from 0.22 to 0.48 mm. It was demonstrated that a lower layer height yielded a more homogeneous distribution of steel fibres within the PLA polymer matrix. The PLA-SSF composites were assessed to evaluate their mechanical performance, volume fraction, morphology and porosity. Composite porosities in the range of 2–21% were obtained. Mechanical testing demonstrated that the stainless steel composites exhibited a twofold increase in interlaminar shear strength (ILSS) and a fourfold increase in its tensile strength compared with the PLA-only polymer prints. When comparing the 4 and 30 Vf% composites, the latter exhibited a significant increase in both the tensile strength and modulus. The ILSS values obtained for the steel composites were up to 28.5 MPa, which is significantly higher than the approximately 13.8 MPa reported for glass fibre-reinforced PLA composites.