Influence of Oil Content on Particle Loading Characteristics of a Two-Stage Filtration System

Abstract

Filter media may encounter aerosols mixed with solid and oil ingredients from various sources, such as industries, transportation, and households, in the air purification process, while the influence such oil content has on the loading performance of single-stage and two-stage filtration systems is under-reported. Thus, this study aims to evaluate oil fraction effects on the loading performance of single-stage and two-stage filtration systems. First, to reveal the oil–solid mixed particle deposition mechanisms, the filter media parameters, i.e., specific cake resistance ε and cake porosity K2, were tested, indicating that a slight amount of oil can increase the dust holding capacity (DHC) of filters by forming a more porous cake, while an excess of oil results in reduced DHC by forming impermeable liquid films on the solid skeleton. Further two-stage experimental results indicate that the effectiveness of a pre-stage filter can be significantly affected by the properties of incoming aerosol and main-stage filters. The utilization of a pre-stage filter unintentionally deteriorated the service lifetime of the main-stage filter when challenged with contaminants with certain oil particles. This counter-intuitive negative phenomenon is due to the special loading behaviors of oil–solid mixed particles. The existing pre-stage filters allow a higher fine oil particle fraction to reach the main-stage downstream, while the induced cake filtration scenario leading to a film clogging scenario adversely reduced the lifetime of the main-stage filter. The findings suggest that the feasibility of a pre-stage in the filtration system requires compressive evaluations according to the specific oil-coated contaminants.