Comparative evaluation to study the effect of implant support on complete fixed dental prosthesis fabricated with peek framework when implants placed in all-on-4 and all-on-6 situation, by strain gauge analysis and finite element analysis – An in vitro study

Abstract

Aim: To evaluate and compare the strain development and distribution of maxillary implant-supported complete fixed dental prosthesis (ISCFDP) with computer-aided design-computer-aided manufacturing milled PEEK BIO-HPP superstructure when placed using All-on-4 and All-on-6 situation using a strain gauge and finite element analysis (FEA). Setting and Design: This is an in vitro study to evaluate and compare the stress minimization and strain developed at implant in premolar and in two clinically simulated situation of All-on-4 and All-on -6 ISCFDP. Materials and Methods: The study involved converting a human skull into. stl format to create 3D-printed stereolithography models with a modulus of elasticity closer to bone. Implants were placed in two models (M1 nad M2) in incisor, premolar, and pterygoid regions. A fixed dental prosthesis framework was fabricated on both models, and strain gauge sensors were attached. Statistical Analysis Used: Descriptive and analytical statistics were done. The normality of data was analyzed by the Shapiro-Wilk test. Results: The results obtained were tabulated and it showed strain around the neck of ISCFDP under 100N configuration in strain gauge analysis. Stress was found more in the molar region when compared to the premolar region. This design showed that the largest stress around the neck of ISFDP under 100 N load was found more in the premolar region when compared to the molar region due to the reduction of stresses in the pterygoid region in FEA. Conclusion: In the present study, strain gauge analysis at 100 N for loading at the premolar and molar region shows the reduced strain on tilted implants in All-on-6 situation due to stress dissipation to the terminal pterygoid implant using strain gauge.