Research of thermal response simulation and mold structure optimization for rapid heat cycle molding processes, respectively, with steam heating and electric heating-Reference-Cited by-同舟云学术

Research of thermal response simulation and mold structure optimization for rapid heat cycle molding processes, respectively, with steam heating and electric heating

Published:2010-01 Issue:1 Volume:31 Page:382-395
ISSN:0261-3069
Container-title:Materials & Design
language:en
Short-container-title:Materials & Design

Author:

Wang Guilong,Zhao Guoqun,Li Huiping,Guan Yanjin

Publisher

Elsevier BV

Subject

Applied Mathematics,General Mathematics

Reference21 articles.

1. Effects of injection-molding conditions on the gloss and color of pigmented polypropylene;Pisciotti;Polym Eng Sci,2005

2. Surface microstructure replication in injection molding;Theilade;Int J Adv Manuf Technol,2007

3. Application of Taguchi optimization technique in determining plastic injection molding process parameters for a thin-shell part;Oktem;Mater Des,2007

4. Experimental characterization of transcription properties of microchannel geometry fabricated by injection molding based on Taguchi method;Kim;Microsyst Technol,2008

5. Heat transfer in injection moulding systems with insulation layers and heating elements;Jansen;Int J Heat Mass Transfer,1995

Cited by 72 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. A review of research progress on the minimization of weld lines in injection molding;The International Journal of Advanced Manufacturing Technology;2024-04-30

2. Stability Analysis of the Rapid Heating Multilayer Structure Mold by the Contact Error and Thickness of Layers;Applied Sciences;2024-03-27

3. Development of a modular mold with a carbon nanotube web film heater for rapid-heating cycle molding;The International Journal of Advanced Manufacturing Technology;2024-03-14

4. Development of a rapid heat cycle injection molding system using infrared radiation and convection heating and influence on morphology and mechanical properties;The International Journal of Advanced Manufacturing Technology;2023-11-24

5. Weld Line Strength of Polyamide Fiberglass Composite at Different Processing Parameters in Injection Molding Technique;Polymers;2023-10-16