Analysis of drill dynamometer with octagonal ring type transducers for monitoring of cutting forces in drilling and allied process-Reference-Cited by-同舟云学术

Analysis of drill dynamometer with octagonal ring type transducers for monitoring of cutting forces in drilling and allied process

Published:2007-01 Issue:2 Volume:28 Page:673-685
ISSN:0261-3069
Container-title:Materials & Design
language:en
Short-container-title:Materials & Design

Author:

Karabay Sedat

Publisher

Elsevier BV

Subject

Applied Mathematics,General Mathematics

Reference23 articles.

1. Analysis and performance testing of a dynamometer for use in drilling and allied process;Venkataraman;Int J Mach Tool Des Res,1965

2. The two-dimensional force dynamometer in cutting process of peripheral milling;Milner;Microtechnic,1982

3. Loeven EG, Cook NH. Metal cutting measurements and their interpretation experimental stress analysis, Cincinatti, OH, vol. VIII(2); 1954. p. 257–62.

4. Machine tool dynamometers;Loewen;Am Mach,1951

5. Comparative assessment of the force prediction abilities of some single edge orthogonal cutting models over diverse data;Venuvinod;Mach Sci Technol,2004

Cited by 33 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Flexure-based torque and thrust force drilling dynamometer with Hall effect sensor displacement measurement;CIRP Annals;2024

2. Review on sensor design for cutting force measurement;Proceedings of the Institution of Mechanical Engineers, Part E: Journal of Process Mechanical Engineering;2022-06-14

3. Materialistic suitability analysis for cutting dynamometers;Journal of Engineering Research;2022-04-06

4. Cross-sensitivity control in a novel four-component milling dynamometer for simultaneous measurement of tri-axial forces and torque;Measurement;2022-03

5. Experimental measurement of the cutting forces and wear of the drill in processing X17CrNi16-2 martensitic stainless steel;Mechanical Sciences;2021-03-04