Anisotropic injection molding of strontium ferrite powder using a PP/PEG binder system-Reference-Cited by-同舟云学术

Anisotropic injection molding of strontium ferrite powder using a PP/PEG binder system

Published:2001-05 Issue: Volume:226-230 Page:1400-1402
ISSN:0304-8853
Container-title:Journal of Magnetism and Magnetic Materials
language:en
Short-container-title:Journal of Magnetism and Magnetic Materials

Author:

Lee S.H,Jeung W.Y

Publisher

Elsevier BV

Subject

Condensed Matter Physics,Electronic, Optical and Magnetic Materials

Reference4 articles.

1. R.M. German, Powder Injection Molding, MPIF, Princeton, NJ, 1990, p. 99.

2. Properties of Anisotropic Nd(Fe, Co)B Type Sintered Magnets Produced by Powder Injection Moulding

3. Petzoldt, H. Eifert, T. Hartwig, G. Veltl, Proceedings of the Advances in Powder Metallurgy and Particular Materials, MPIF, Princeton, NJ, 1995, p. 6.

4. Effects of binder and thermal debinding parameters on residual carbon in injection moulding of Nd(Fe,Co)B powder

Cited by 18 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Recycled Polypropylene/Strontium Ferrite Polymer Composite Materials with Electromagnetic Shielding Properties;Polymers;2024-04-17

2. Synergy of low-and high-density polyethylene in a binder system for powder injection molding of SiC ceramics;Ceramics International;2022-09

3. 316L FFF binder development and debinding optimization;Materials Research Express;2021-11-01

4. Effect of magnetic powder content on circumferential anisotropy of centrifugally cast bonded magnets;Journal of Magnetism and Magnetic Materials;2021-07

5. On the potential of hard ferrite ceramics for permanent magnet technology—a review on sintering strategies;Journal of Physics D: Applied Physics;2021-05-14