Synthetic polyampholytes based on acrylamide derivatives – new polymer for enhanced oil recovery

Abstract

Background: Due to its high efficiency, polymer flooding has been widely used in the fields of Kazakhstan. However, under conditions of high water salinity, high concentrations of polymers are needed to ensure the design viscosity of the solutions, therefore, polymers are needed that, at concentrations not exceeding 0.10.2%, will increase the viscosity of water up to 2050 cP when the formation water salinity is above 200 g/ l. Aim: The purpose of this work is to study the salt- and heat-resistant properties of a linear polyampholyte based on acrylamide, an anionic monomer sodium salt of 2-acrylamido-2-methyl-1-propanesulfonic acid - and a cationic monomer (3-acrylamidopropyl) trimethylammonium chloride and substantiate its applicability in oil production. Materials and methods: We used water with a salinity of 200300 g/l, as well as oils with viscosities of 60, 138, and 420 cP. To simulate a porous medium, bulk sand models and aerated concrete with high porosity were chosen. Hydrolyzed polyacrylamide with a molecular weight of 17 million Da and a ternary polyampholyte with a molecular weight of 2.9 million Da were used as polymers. To compare the effectiveness of these polymers under conditions of high salinity, experiments were carried out to measure the dynamic viscosity and oil displacement efficiency. Results: It is shown that the injection of a 0.25% solution of triple polyampholyte dissolved in water with a salinity of 200 g/l into sand models increases the oil displacement efficiency by 2328% compared to the injection of formation water. Under identical conditions, the injection of a hydrolyzed polyacrylamide solution resulted in an increase in the oil displacement efficiency by only 18%. Conclusion: Triple polyampholyte based on acrylamide derivatives has superior oil displacement properties compared to hydrolyzed polyacrylamide in high salinity reservoirs. The results of laboratory experiments can draw the attention of oil and gas industry specialists and subsoil users to new developments by the staff of the Institute of Polymer Materials and Technologies in terms of scaling up synthetic polyampholytes and conducting pilot tests.