Author:
Zhang Qiuyue,Lu Guangda,Chen Ying,Guo Tinghang,Han Yu,Qie Tongtong
Abstract
Abstract
This paper analyzes the flexion and extension of three joints of a single exoskeleton mechanical finger. According to the motion characteristics of the finger, a finger rehabilitation exoskeleton robot is designed to assist patients with hand function for rehabilitation training. The three-dimensional model was established by SolidWorks, and the initial state of the robot was set under the action of gravity. The finite element analysis method was used to analyze the stress of the key components, including calculate and analyze its stress and strain. The simulation showed that the maximum stress of key components in rehabilitation training was 2140 (Pa), which is far less than the yield strength of the material 60 (MPa), and the maximum deformation was 0.092 (mm). The simulation result revealed that our design did not lead to failure of mechanical structure, which would provide a certain reference basis for its structural optimization design.
Subject
General Physics and Astronomy
Reference15 articles.
1. Stroke epidemiology in the developing world[J];Feigin;Lancet,2005
2. Constraint-induced movement therapy: A new family of techniques with broad application to physical rehabilitation-acinical review[J];Taub;J Rehab Res Dev.,1999
3. Haptic-Based Neurorehabilitation in Poststroke Patients: A Feasibility Prospective Multicentre Trial for Robotics Hand Rehabilitation[J];Turolla;Computational and Mathematical Methods in Medicine,2013
4. Use-dependent plasticity of the human motor cortex in health and disease[J];Sawaki;IEEE Eng Med Biol Mag,2005
Cited by
2 articles.
订阅此论文施引文献
订阅此论文施引文献,注册后可以免费订阅5篇论文的施引文献,订阅后可以查看论文全部施引文献