Autonomous spheroid formation by culture plate compartmentation

Abstract

Abstract Scaffold-free 3D cell cultures (e.g. pellet cultures) are widely used in medical science, including cartilage regeneration. Their drawbacks are high time/reagent consumption and lack of early readout parameters. While optimisation was achieved by automation or simplified spheroid generation, most culture systems remain expensive or require tedious procedures. The aim of this study was to establish a system for resource efficient spheroid generation with additional early readout parameters. This was achieved by a new approach for spheroid generation via self-assembly from monolayer via compartmentation of cell culture surfaces utilising laser engraving (grid plates). The compartmentation triggered contraction and rolling up of the cell monolayer, finishing in condensation into a spheroid in human adipose-derived stem cell (ASC/TERT1) and human articular chondrocytes (hACs)-ASC/TERT1 co-cultures, when cultivated on grid plates under chondrogenic conditions. Plates with 1 and 3 mm grid size yielded stable diameters (about 140 µm and 300 µm, respectively). ASC/TERT1 spheroids fully formed within 3 weeks while co-cultures took 1–2 weeks, forming significantly faster with increasing hAC ratio (p < 0.05 and 0.01 for 1:1 and 1:4 ASC/TERT1:hAC ratio, respectively). Co-cultures showed slightly lower spheroid diameters, due to earlier spheroid formation and incomplete monolayer formation. However, this was associated with a more homogeneous matrix distribution in the co-culture. Both showed differentiation capacity comparable to standard pellet culture in (immune-)histochemistry and RT-qPCR. To assess usability for cartilage repair, spheroids were embedded into a hydrogel (fibrin), yielding cellular outgrowth and matrix deposition, which was especially pronounced in co-cultures. The herein presented novel cell culture system is not only a promising tool for autonomous spheroid generation with the potential of experimental and clinical application in tissue engineering, but also for the generation of ‘building blocks’ for subsequential biofabrication strategies such as bioprinting.