Accuracy Assessment for points coordinates surveyed using low-cost Unmanned Aerial Vehicle and Global Positioning System with 3Dsurvey and 3DF Zephyr software

Abstract

AbstractGround Control Points GCPs are the only way to obtain accurate positions in aerial surveys. At least three points should be utilized, and the model will get increasingly accurate in X, Y, and Z coordinates as the number rises. The accuracy of the 3D model created from aerial photography is also affected by the arrangement of GCPs. The goal of this research is to determine the optimal number and arrangement of GCPs in order to obtain the lowest possible error in point positioning. A conventional UAV called DJI Mavic 2 pro was used to photograph one and a half square kilometer site at an elevation equal to hundred meters from earth’s surface with nadir camera configuration. GSD (ground sampling distance) of 2.3 centimeters was used to collect 1515 pictures. 62 GCPs were observed in PPK (Post Processing kinematic) method using a DGPS (differential global positioning system) receiver GS 15 from Leica. The study area was split into two areas, one with a straight arrangement of GCPs and the other with a diagonal arrangement of GCPs. The pictures were processed using 3Dsurvey and 3DF Zephyr software utilizing a full bundle adjustment procedure with increasing GCPs number beginning with three GCPs and ending with twenty-six GCPs for both arrangement layout, with the other points serving as check points for the model’s accuracy at each attempt. The check point coordinates obtained were compared to the DGPS coordinates. The result indicates the optimal GCP number needed for the most accurate position and spread layout. That the minimum gap between adjacent GCPs ought to be not over than 100 meters and spread homogenously.