Visualization of counter pressure mechanism in gas-assisted injection molding process-Reference-Cited by-同舟云学术

Visualization of counter pressure mechanism in gas-assisted injection molding process

Published:2017-08-09 Issue:6 Volume:40 Page:459-470
ISSN:0253-3839
Container-title:Journal of the Chinese Institute of Engineers
language:en
Short-container-title:Journal of the Chinese Institute of Engineers

Author:

Jong Wen-Ren¹,Hwang Shyh-Shin²,Kao Chi-Hung¹,Huang Yan-Mao¹,Wu Chien-Chou¹,Hong Song-Hong¹

Affiliation:

1. Department of Mechanical Engineering, Chung Yuan Christian University, Taoyuan City, Taiwan, R.O.C

2. Department of Mechanical Engineering, Chien Hsin University of Science and Technology, Chien Hsin University, Taoyuan City, Taiwan, R.O.C.

Publisher

Informa UK Limited

Subject

General Engineering

Link

https://www.tandfonline.com/doi/pdf/10.1080/02533839.2017.1362356

Reference14 articles.

1. Chen, L. L. 2002. “A New Design Method of Fish Tail Die to Improve Flow Uniformity in Micro Injection/Extrusion Processes.” Master Thesis, National Yunlin University of Science and Technology.

2. Visualization of in-mold shrinkage in injection molding process

3. Hsiao, Y. L. 2011. “Study of Foaming Control and Part Mechanical Properties during Microcellular Injection Molding Process via a Mechanism of Gas Counter Pressure and Dynamic Mold Temperature Variation.” Master Thesis, Chung Yuan Christian University.

4. Hsieh, I. C. 2006. “Visualization of In-mold Constraint to Affect Shrinkage of Micro Holes during Injection Molding.” Master Thesis, National Yunlin University of Science and Technology.

5. Hsu, K. S. 1995. “Fundamental Study of Gas-Assisted Injection Molding Process.” Master Thesis, Chung Yuan Christian University.

Cited by 3 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Investigation of microstructural and mechanical properties of weld lines in injection‐molded short glass fiber‐reinforced polyamide 6;Polymer Composites;2024-03-30

2. Experimental analysis of fluid‐assisted injection molding of pipe fittings with different angles by short‐shot method;Engineering Reports;2022-09-14

3. Temperature and shear rate distributions of gas-assisted injection molded (GAIM) polypropylene and the application in forecast of cooling time;Journal of Applied Polymer Science;2018-12-21