Research on pipeline leakage localization method based on CZIM algorithm

Abstract

AbstractThe time difference of arrival is a common method to find the leakage point of water pipeline. The leakage point localization is achieved by calculating the time delay between the signals reaching different sensors. Mainstream time delay estimation algorithms based on signal correlation analysis are susceptible to the introduction of noise signals, low sampling rates, and signal clipping, resulting in inaccurate localization results. The article analyzed the impact of different interference factors and proposed a new time delay estimation algorithm based on signal cross-zero information modulation (CZIM) to address these problems. By normalizing the amplitude of the two signals at the detection points on both sides of the pipeline leakage position, two sets of sparse signal sequences with only two eigenvalues of 0 and 1 are obtained. The error coefficient function is calculated by a similar traversal method to finally index the time delay. In this paper, the principle and characteristics of the algorithm are analyzed and compared with the most commonly used GCC method. In both numerical simulations and actual pipe leakage localization experiments, the CZIM algorithm has shown its wide applicability, low impact by low sampling rate, and adaptability to low signal-to-noise ratios, etc. At the same time, the algorithm is simple in design and has a small amount of calculation and can meet the demand for real-time data processing, providing a new idea for the development of acoustic localization technology.